High-lifter Max Clearance Front Lower Control Arms for Can-Am Uživatelský manuál stáhnout pdf

780 Professional Drive N. Shreveport, LA 71105 Phone (318)-524-2270 Fax (318)-524-2297

Max Clearance Can-Am

Front Lower Arched Control Arm Kit

The Max Clearance Control Arm Kit is designed to increase ground clearance on the

Can-Am Model ATV’s. High Lifter expressly disclaims responsibility for accidents or

injury or consequential damage to original equipment that may be said to arise out of use

of large oversized tires, lift kits, or this product. High Lifter strongly recommends that

helmets and all appropriate safety equipment be worn when riding ATVs/RUVs and in

particular when riding lifted and/or modified ATVs/RUVs with oversized tires.

If this product is not what you expected, or is not consistent with your intended use, you

should return the product immediately to the seller, before installation, for a refund of the

purchase price; less any fees. After installation, product is warranted for 90 days for

defects in workmanship and materials. Warranty is limited to refund of the purchase

price or replacement of the kit, at the seller’s option.

Dealers, Installers and Owners of Vehicle

You are responsible for informing your customer or purchaser of the information

contained above and the increased potential hazards of operating an ATV/ RUV equipped

with these modifications. If you install the kit, it is your responsibility to also install the

warning label prominently in view of the driver and in prominent view of the driver and

passenger on RUVs and multi-passenger ATVs. They should also be instructed to notify

anyone operating the vehicle, as well as any passengers, that modifications are installed.

1 2 3 4 5 6

1 780 Professional Drive N. Shreveport, LA 71105 Phone (318)-524-2270 Fax (318)-524-2297 Max Clearance Can-Am Front Lower Arched Control Arm Kit

2 Parts Diagram

3 Installation Instructions: 1. Place jack under center of front end and lift until front wheels clear the ground. Be careful to support properly s

4 5. Remove the bushings, sleeves, and ball joints from the stock control arms. You will need to reuse these in the new Control Arm kit. 6.

5 7. Now reinstall the bushings, sleeves, and ball joints into the new arms. If you place some grease on them it makes the installations easier.

6 8. Use the factory nuts and bolts to connect the new Control Arms to the RUV frame. You will have left and right lower Control Arms. Left and ri

Žádné komentáře

High-lifter Max Clearance Front Lower Control Arms for Can-Am Uživatelský manuál