High-lifter Crushlok Wheels 12” & 14” Installation Uživatelský manuál stáhnout pdf

High Lifter Products, Inc. (318) 524-2270

780 Professional Dr. N Fax (318) 524-2297

Shreveport, LA 71105

Crushlok Wheels 12” & 14” Assembly Instructions

Parts Diagram

Disclaimer:

The High Lifter Crushlok wheels are intended for competitive mud racing in mud and water filled pits and not

for trail riding. They are designed to minimize resistance to forward progress by presenting a very narrow

profile and to reduce buoyancy by narrowing the carcass of the tire and weighing approximately 2 times that of

other stock or aftermarket wheels. Accordingly, these wheels are not recommended for trail riding or

recreational riding and are without warranty of any kind.

Note: There is an optional install kit (12C-LOK-KIT) that can be purchased with these wheels. Illustrations

and photos in these instructions are performed using the install kit. Also, flange style lug nuts are required

when using these wheels. Use factory torque specifications when installing these wheels.

The wheels are available in both 12” and 14” sizes and each size is drilled in 4 bolt patterns, 4/110, 4/115, 4/137

and 4/156. Due to center locator tabs on Polaris and some other models of ATV hubs, either 1” spacers or

alteration of hubs is required. Some models with these locator tabs can be adjusted for with the addition of

washers but this depends on the stud length in the hub.

Warranty:

These wheels are designed and constructed for competition mud racing. As such there is no guarantee or

warranty of any kind furnished with them.

1 2 3 4 5

High Lifter Products, Inc. (318) 524-2270 780 Professional Dr. N Fax (318) 524-2297 Shreveport, LA 71105 Crushlok W

Optional Install Kit Assembly (12C-LOK-KIT): 1. Using two of the 5/16 nuts, install them onto the all thread rod. Using two wrenches “lock” them t

Wheel Assembly Instructions: 1. Place the center of the wheel into the tire. Note direction of the tire to make sure the valve stem is facing outwar

4. Repeat the first three steps until you have all rods in place. Picturing the wheel as a clock, you want to have the rods at 12, 4, and 7.

6. Next, install the 5/16 x 2” bolts and 5/16 washers, placing washers on the outsides of the rings so that the rings are not damaged. Then install

Žádné komentáře

High-lifter Crushlok Wheels 12” & 14” Installation Uživatelský manuál